Monopattino elettrico ENGWE Y600 Motore da 600W batteria 48.1V 18.2Ah 875Wh Velocità massima da sbloccato 42km/h
Autonomia massima 70km gomme da 10 pollici
Prendilo qui direttamente sul sito ufficile Engwe a €529 con codice sconto ✂️: Sindroy100
🚚💨Consegna gratuita da magazzino Europeo, 7-10 giorni lavorativi (magazzino Europeo, no tasse doganali)
Istruzioni del display multifunzione:
P01: Backlight brightness, level 1 is the darkest and level 3 is the brightest;
P02: Mileage unit, 0: KM; 1: MILE;
P03: Voltage level: 24V, 36V, 48V, default 36V;
P04: Sleep time: 0, no sleep; other numbers are sleep time, range: 1-60; unit minute;
P05: Power-assisted drive gear setting;
P06: Wheel diameter: unit, inch; accuracy: 0.1;
P07: Number of speed measuring magnets: Range: 1-100;
P08: Maximum operating speed of speed-limited motor;
P09: Zero start, non-zero start setting, 0: zero start; 1: non-zero start;
P10: Drive mode setting: 0 power-assisted drive, 1 electric drive, 2 power-assisted drive, electric drive coexist;
P11: Assist sensitivity setting 1-24;
P12: Starting torque: Range: 0-5, 0 is the weakest, 5 is the strongest;
P13: Power boost plate magnet type setting 5812
P14: Controller current limit value setting default 12A range: 1-20A; (requires controller software support)
P15: Motor drive signal percentage setting (to realize the speed limit function of PO8), the full speed is set to 100
P16: Instrument real-time cruise function 1 has this function 0 does not have this function
P17: Headlight synchronization function 1 The headlights and backlight do not light up after turning on the machine 0 The headlights and backlight light up after turning on the machine
P18: Power-on password selection function 1 has this function 0 does not have this function
P99: One-click recovery function (press and hold the MODE button for 5-6 seconds in the P99 parameter setting interface to restore all parameters to the first
Initial settings for the first boot)
ODO: ODO reset (in the ODO parameter setting interface, press the MODE button briefly and then press and hold for 5M-6 seconds until the number is zero and release)
2988